Hello,

I am connecting to the internet through a pppoe connection, but for some reason I can not connect to my modem (it's address is 192.168.1.1).

Before I set my pppoe connection, I could connect.

So, is there a way?

EDIT

The output of ifconfig is :

r@PlaviZec:~$ ifconfig
eth0      Link encap:Ethernet  HWaddr 00:13:d4:f7:02:d4  
          inet6 addr: fe80::213:d4ff:fef7:2d4/64 Scope:Link
          UP BROADCAST RUNNING MULTICAST  MTU:1500  Metric:1
          RX packets:2811 errors:0 dropped:0 overruns:0 frame:0
          TX packets:2801 errors:0 dropped:0 overruns:0 carrier:0
          collisions:0 txqueuelen:1000 
          RX bytes:2538831 (2.5 MB)  TX bytes:448591 (448.5 KB)
          Interrupt:21 Base address:0xa000 

lo        Link encap:Local Loopback  
          inet addr:127.0.0.1  Mask:255.0.0.0
          inet6 addr: ::1/128 Scope:Host
          UP LOOPBACK RUNNING  MTU:16436  Metric:1
          RX packets:28 errors:0 dropped:0 overruns:0 frame:0
          TX packets:28 errors:0 dropped:0 overruns:0 carrier:0
          collisions:0 txqueuelen:0 
          RX bytes:1600 (1.6 KB)  TX bytes:1600 (1.6 KB)

ppp0      Link encap:Point-to-Point Protocol  
          inet addr:92.229.42.177  P-t-P:213.191.64.59  Mask:255.255.255.255
          UP POINTOPOINT RUNNING NOARP MULTICAST  MTU:1492  Metric:1
          RX packets:2794 errors:0 dropped:0 overruns:0 frame:0
          TX packets:2741 errors:0 dropped:0 overruns:0 carrier:0
          collisions:0 txqueuelen:3 
          RX bytes:2476277 (2.4 MB)  TX bytes:381240 (381.2 KB)