Debian software raid 1: boot from both disk
Posted
by
bsreekanth
on Super User
See other posts from Super User
or by bsreekanth
Published on 2011-03-15T21:02:54Z
Indexed on
2011/06/29
8:25 UTC
Read the original article
Hit count: 429
I newly installed debian squeeze with software raid.The way I did was, as also given in this thread.
- I have 2 HDD with 500 GB each. For each of them, I created 3 partitions (/boot, / and swap)
- I selected the hard drive and created a new partition table
- I created a new partition that was 1GB. I then specified to use the partition as a Physical Volume for RAID. and used for /boot and enabled bootable.
- Created another partition, which is of 480 GB, and then specified to use the partition as a Physical Volume for RAID. and used for /.
- Created another partion and used for swap
Then RAID configuration:
Through Configure RAID menu -> create MD device -> (2 for the number of drives, 0 for spare devices)
Next select the partitions you want to be members of /dev/MD0. I selected /dev/sda1 and /dev/sdb1 (for /boot) Next select the partitions you want to be members of /dev/MD1. I selected /dev/sda6 and /dev/sdb6 (for /) And no RAID for swap partitions
'Finish Partitioning and write changes to disk' --> Finish the rest of the install like normal
Everything is ok now, except I am not sure how to test my raid config. When I pull the power of the HDD, it only boots from one disk. I read in some forum that I may have to install GRUB manually on the other.
In Debian Squeeze, there is no grub command. Not sure how to make my software raid bootable from both disk.
Also, please comment on my steps above. Anything unusual. I configured /boot partitions of both disks to be boot=yes. Not sure whether that is ok.
Thanks,
Bsr
© Super User or respective owner