IPsec VPN tunnel between Windows 2008 R2 and CISCO ASA?
Posted
by
antur123
on Server Fault
See other posts from Server Fault
or by antur123
Published on 2012-03-22T11:09:09Z
Indexed on
2012/03/22
11:31 UTC
Read the original article
Hit count: 249
I need to create a VPN IPsec tunnel between my Windows 2008 R2 server and a CISCO ASA device.
I want my server to be both the end of the tunnel, and the server that connects to the other side (no need to connect a whole subnet, just the server would be fine).
I found this article that seems to do the trick, but there are two differences:
- As mentioned above, the computer behind my end is the server itself. Can that be configured? (i.e. make the "computers in endpoint 1" IP address be the same than "local tunnel computer").
- This article is for Juniper ScreenOS, not for CISCO ASA, though configurations look very similar.
Would that configuration work for me?
© Server Fault or respective owner
