How do I configure networking on CentOS 6 running on hyper-v?
Posted
by
LonelyLonelyNetworkN00b
on Server Fault
See other posts from Server Fault
or by LonelyLonelyNetworkN00b
Published on 2011-12-20T16:57:35Z
Indexed on
2012/10/04
15:41 UTC
Read the original article
Hit count: 250
I'm not using legacy adapters, and i've installed Linux Integration Components 3.2.
THe problem i'm facing is that the command 'setup' or 'system-config-network' doesn't list any network interfaces. If i run ifconfig -a i can see both the network cards i've attached. By setting a ip using ifconfig i can get network connectivity. The problem is that it's not persistent after a reboot.
I'm a 100% centos newbie, but I figure it has something to do with that the centos installer couldn't see the NICs on install.
How can I fix this?
© Server Fault or respective owner