Trunking at Router Port

Posted by singh on Server Fault See other posts from Server Fault or by singh
Published on 2012-10-09T09:22:31Z Indexed on 2012/10/09 9:39 UTC
Read the original article Hit count: 203

Filed under:

vlan

After reading a bit about interVLAN routing got a doubt regarding how trunking takes place at router and at switch.In case of switch we configure a port interface as trunk port and say all vlan's are allowed here but in case of router we configure sub interface as trunk saying particular vlan belongs to particular subinterface .Can't we configure only a single port interface on router just like Switch and say all vlan's are allowed here on this interface ,why to go for sub interfaces?

Hope I'm able to put my question in right way.

Related posts about vlan

Cisco vlan entry missing in vlan.dat, but appears in running-config

as seen on Server Fault - Search for 'Server Fault'
One of our vlan's (ID: 104) stopped working suddenly and computers on that vlan failed when trying to obtain a dhcp ip address. On the Cisco switch if we do show vlan, this command is supposed to shows the vlans in the vlan.dat file. We notice it has every other vlan except the one that is now missing… >>> More
Unable to access VLAN host from VLAN interface in CentOS

as seen on Server Fault - Search for 'Server Fault'
I am playing with VLAN (Virtual LAN) configuration on CentOS 6.4. I have 2 interfaces, eth0 and eth1. I have configured 2 VLAN interfaces eth0.20 and eth0.30 as #file: ifcfg-eth0.20 #------------- VLAN=yes DEVICE=eth0.20 TYPE=Ethernet ONBOOT=yes NM_CONTROLLED=no BOOTPROTO=static IPADDR=192.168… >>> More
Multiple vlans access to shared pbx system

as seen on Server Fault - Search for 'Server Fault'
I'm new to networking and was looking for some assistance. First off I'm using packet tracer to diagram my scenario as I will be receiving my equipment next week to deploy. Hardware to be used: 2 catalyst 3560 switches all connect to a sonic wall router I have two companies that work in the… >>> More
VLAN ID 4095 for guest VLAN tagging

as seen on Server Fault - Search for 'Server Fault'
Just want to know if it's true that if you use the VLAN ID 4095 for guest VLAN tagging, then vMotion will not work correctly as there is nowhere to pass back the reverse arp to? So, the problem we have noticed is when we have vmotioned VM's that are tagged on our trunk network, you cannot ping them… >>> More
vlan change via scvmm not working

as seen on Server Fault - Search for 'Server Fault'
Hi i have a windows 2008 R2 hyper-v server which is managed via scvmm 2008 R2. the guest os running on the hyper-v server is winxp with sp3. if i change the vlan id via scvmm the guest doesn't get an ip via dhcp i looked in the properties of the vm with the hyper-v mmc an see the vlan changed correctly… >>> More

Developer IT