Wireless is detected, but not connecting. Ethernet works. How to correct the wireless address?
Posted
by
Lucas
on Ask Ubuntu
See other posts from Ask Ubuntu
or by Lucas
Published on 2014-06-05T02:29:40Z
Indexed on
2014/06/05
3:38 UTC
Read the original article
Hit count: 402
I am running Ubuntu 14.04 with cable internet, and my wireless is detected and connected, but I cannot connect to the internet. I know the problem is with my machine because other machines are connecting to the same router just fine. I can connect via ethernet just fine as well.
Here are some notable tests:
ping 192.168.0.105
works with 0% packet loss, but ping 192.168.0.1
has 100% packet loss.
When I plug in my ethernet, ping 192.168.0.1
works with 0% packet loss.
My wireless name is tg
, and the router ip is 192.168.0.1
(where I can enter username and password). I suspect that I need to change my wireless address from 192.168.0.105
to 192.168.0.1
. Any suggestions on how to proceed?
extra info:
[lucas@lucas-ThinkPad-W520]/home/lucas$ iwconfig
eth0 no wireless extensions.
lo no wireless extensions.
wlan0 IEEE 802.11abgn ESSID:"tg"
Mode:Managed Frequency:2.462 GHz Access Point: 00:02:6F:83:F8:F4
Bit Rate=1 Mb/s Tx-Power=15 dBm
Retry long limit:7 RTS thr:off Fragment thr:off
Power Management:off
Link Quality=62/70 Signal level=-48 dBm
Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0
Tx excessive retries:52 Invalid misc:166 Missed beacon:0
[lucas@lucas-ThinkPad-W520]/home/lucas$ ifconfig
eth0 Link encap:Ethernet HWaddr f0:de:f1:b2:53:53
inet addr:192.168.0.100 Bcast:192.168.0.255 Mask:255.255.255.0
inet6 addr: fe80::f2de:f1ff:feb2:5353/64 Scope:Link
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:980003 errors:0 dropped:0 overruns:0 frame:0
TX packets:498384 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:1320506168 (1.3 GB) TX bytes:59780591 (59.7 MB)
Interrupt:20 Memory:f3a00000-f3a20000
lo Link encap:Local Loopback
inet addr:127.0.0.1 Mask:255.0.0.0
inet6 addr: ::1/128 Scope:Host
UP LOOPBACK RUNNING MTU:65536 Metric:1
RX packets:21927 errors:0 dropped:0 overruns:0 frame:0
TX packets:21927 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:1781719 (1.7 MB) TX bytes:1781719 (1.7 MB)
wlan0 Link encap:Ethernet HWaddr 24:77:03:29:8f:dc
inet addr:192.168.0.105 Bcast:192.168.0.255 Mask:255.255.255.0
inet6 addr: fe80::2677:3ff:fe29:8fdc/64 Scope:Link
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:11828 errors:0 dropped:0 overruns:0 frame:0
TX packets:15444 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:4855662 (4.8 MB) TX bytes:2250585 (2.2 MB)
[lucas@lucas-ThinkPad-W520]/home/lucas$ lspci -nn | grep 0280
03:00.0 Network controller [0280]: Intel Corporation Centrino Ultimate-N 6300 [8086:4238]
(rev 3e)
[lucas@lucas-ThinkPad-W520]/home/lucas$ rfkill list
0: hci0: Bluetooth
Soft blocked: no
Hard blocked: no
1: tpacpi_bluetooth_sw: Bluetooth
Soft blocked: no
Hard blocked: no
2: phy0: Wireless LAN
Soft blocked: no
Hard blocked: no
with ethernet unplugged:
[lucas@lucas-ThinkPad-W520]/home/lucas$ route -n | grep UG
0.0.0.0 192.168.0.1 0.0.0.0 UG 0 0 0 wlan0
with ethernet plugged in:
[lucas@lucas-ThinkPad-W520]/home/lucas$ route -n | grep UG
0.0.0.0 192.168.0.1 0.0.0.0 UG 0 0 0 eth0
[lucas@lucas-ThinkPad-W520]/home/lucas$ nm-tool
NetworkManager Tool
State: connected (global)
- Device: wlan0 [tg] ----------------------------------------------------------
Type: 802.11 WiFi
Driver: iwlwifi
State: connected
Default: no
HW Address: 24:77:03:29:8F:DC
Capabilities:
Speed: 52 Mb/s
Wireless Properties
WEP Encryption: yes
WPA Encryption: yes
WPA2 Encryption: yes
Wireless Access Points (* = current AP)
tatum: Infra, 40:8B:07:D8:A5:04, Freq 2437 MHz, Rate 54 Mb/s, Strength
42 W
PA WPA2
ums: Infra, 00:20:A6:72:52:BF, Freq 2437 MHz, Rate 54 Mb/s, Strength 59
Alpha 40: Infra, 28:CF:E9:86:59:5D, Freq 5260 MHz, Rate 54 Mb/s, Strength 30 W
PA WPA2
thepromiselan: Infra, 58:6D:8F:51:E5:54, Freq 2452 MHz, Rate 54 Mb/s, Strength 34 $
PA WPA2
xfinitywifi: Infra, 06:1D:D5:84:27:A0, Freq 2437 MHz, Rate 54 Mb/s, Strength 52
*tg: Infra, 00:02:6F:83:F8:F4, Freq 2462 MHz, Rate 54 Mb/s, Strength 73 W
PA2
ums: Infra, 00:20:A6:A1:9F:25, Freq 2452 MHz, Rate 54 Mb/s, Strength 44
BRIAN-PC_Network:Infra, 20:AA:4B:DD:93:D6, Freq 2462 MHz, Rate 54 Mb/s, Strength 35 W
PA2
HOME-C0F8: Infra, 44:32:C8:D2:C0:F8, Freq 2412 MHz, Rate 54 Mb/s, Strength 40 W
PA WPA2
abcsexy: Infra, 28:28:5D:27:5D:85, Freq 2412 MHz, Rate 54 Mb/s, Strength 27 W
PA WPA2
IPv4 Settings:
Address: 192.168.0.105
Prefix: 24 (255.255.255.0)
Gateway: 192.168.0.1
DNS: 192.168.0.1
- Device: eth0 [Wired connection 1] -------------------------------------------
Type: Wired
Driver: e1000e
State: connected
Default: yes
HW Address: F0:DE:F1:B2:53:53
Capabilities:
Carrier Detect: yes
Speed: 100 Mb/s
Wired Properties
Carrier: on
IPv4 Settings:
Address: 192.168.0.100
Prefix: 24 (255.255.255.0)
Gateway: 192.168.0.1
DNS: 192.168.0.1
© Ask Ubuntu or respective owner