Hi I got a Raspberry Pi at A.A.A.B in my local network and I have set up a DMZ on my router so that any incoming traffic that comes to my router gets redirected to my raspberry pi wich I can connect via NO-IP adress.

The problem is that I want to set up portforwarding since i got several services running on my Pi like SSH, torrent webgui, webalbum, etc.

I had this already done before long time ago, but I forgot a bit the syntax and cant get to set it up.

Router Help says: The Application allows you to do port forwarding, but only have the ports open when data flowing out of the trigger ports. When a program sends data out on outgoing ports called trigger ports, the device then allows incoming data on the open ports specified in your port triggering configuration.

1.Trigger Port Start

Trigger Port Start Specify the start port on the device that would trigger the device to open ports for incoming data.

2.Trigger Port End

Specify the end port on the device that would trigger the device to open ports for incoming data. You can enter a port number the same as the trigger port start or enter a larger port number to specify a port range.

3.Trigger Traffic Protocol Type

Select the trigger traffic type. Open Port Specify all the ports to be opened. It's content could be: A single port only. A port range only. Start open port number and end port number should be separated by "-" . Combined several single port and several port ranges. Each single port or port range should be separated by "," . Open Traffic Protocol Type Select the open traffic type.

This are the fields:

http://es.tinypic.com/view.php?pic=n5lv1k&s=8

I think this is the syntax 1-7999,8001-9090,9092-65535.

But each time I want to add it gives me an error.

Any ideas?