This is similar to some other questions, but I have a specific need which is not covered in the other questions. I have an Ubuntu server (11.10) with two NICs. One is built into the motherboard and the other is a PCI express card. I want to have my server connected to the internet via my NAT router and also have it able to wake from suspend using a Magic Packet (henceforth referred to as Wake-On-LAN, WOL). I can't do this with just one of the NICs because each has an issue - the built-in NIC will crash the system if it is placed under heavy load (typically downloading data), whilst the PCI express NIC will crash the system if it is used for WOL. I have spent some time investigating these individual problems, to no avail. My plan is thus: use the built-in NIC solely for WOL, and use the PCI express card for all other network communication except WOL. Since I send the WOL Magic Packet to a specific MAC address, there is no danger of hitting the wrong NIC, but there is a danger of using the built-in NIC for general network access, overloading it and crashing the system. Both NICs are wired to the same LAN with address space 192.168.0.0/24. The built-in ethernet card is set to have interface name eth1 and the PCI express card is eth0 in Ubuntu's udev persistent rules (so they stay the same upon reboot). I have been trying to set this up with the /etc/network/interfaces file. Here is where I am currently: auto lo iface lo inet loopback auto eth0 iface eth0 inet static address 192.168.0.3 netmask 255.255.255.0 network 192.168.0.0 broadcast 192.168.0.255 gateway 192.168.0.1 auto eth1 iface eth1 inet static address 192.168.0.254 netmask 255.255.255.0 I think by not specifying a gateway for eth1, I prevent it being used for outgoing requests. I don't mind if it can be reached on 192.168.0.254 on the LAN, i.e. via SSH -- it's IP is irrelevant to WOL, which is based on MAC addresses -- I just don't want it to be used to access internet resources. My kernel routing table (from route -n) is Kernel IP routing table Destination Gateway Genmask Flags Metric Ref Use Iface 0.0.0.0 192.168.0.1 0.0.0.0 UG 100 0 0 eth0 169.254.0.0 0.0.0.0 255.255.0.0 U 1000 0 0 eth0 192.168.0.0 0.0.0.0 255.255.255.0 U 0 0 0 eth0 192.168.0.0 0.0.0.0 255.255.255.0 U 0 0 0 eth1 My question is this: Is this sufficient for what I want to achieve? My research has thrown up the idea of using static routing to specify that eth1 should only be used for WOL on the local network, but I'm not sure this is necessary. I have been monitoring the activity of the interfaces using iptraf and it seems like eth0 takes the vast majority of the packets, though I am not sure that this will be consistent based on my configuration. Given that if I mess up the configuration, my system will likely crash, it is important to me to have this set up correctly!