Can't configure frame relay T1 on Cisco 1760
- by sonar
For the past few days I've been trying to configure a data T1 via a Frame Relay. Now I've been pretty unsuccessful at it, and it's been a while, since I've done this so please bare with me.
The ISP provided me the following information:
1. IP address
2. Gateway address
3. Encapsulation Frame Relay
4. DLCI 100
5. BZ8 ESF (I think the bz8 was supposed to be b8zs)
6. Time Slot (1 al 24).
And what I have configured up until now is the following:
interface Serial0/0
ip address <ip address> 255.255.255.252
encapsulation frame-relay
service-module t1 timeslots 1-24
frame-relay interface-dlci 100
sh service-module s0/0 (outputs):
Module type is T1/fractional
Hardware revision is 0.128, Software revision is 0.2,
Image checksum is 0x73D70058, Protocol revision is 0.1
Receiver has no alarms.
Framing is **ESF**, Line Code is **B8ZS**, Current clock source is line,
Fraction has **24 timeslots** (64 Kbits/sec each), Net bandwidth is 1536 Kbits/sec.
Last module self-test (done at startup): Passed
Last clearing of alarm counters 00:17:17
loss of signal : 0,
loss of frame : 0,
AIS alarm : 0,
Remote alarm : 2, last occurred 00:10:10
Module access errors : 0,
Total Data (last 1 15 minute intervals):
0 Line Code Violations, 0 Path Code Violations
0 Slip Secs, 0 Fr Loss Secs, 0 Line Err Secs, 0 Degraded Mins
0 Errored Secs, 0 Bursty Err Secs, 0 Severely Err Secs, 0 Unavail Secs
Data in current interval (138 seconds elapsed):
0 Line Code Violations, 0 Path Code Violations
0 Slip Secs, 0 Fr Loss Secs, 0 Line Err Secs, 0 Degraded Mins
0 Errored Secs, 0 Bursty Err Secs, 0 Severely Err Secs, 0 Unavail Secs
sh int:
FastEthernet0/0 is up, line protocol is up
Hardware is PQUICC_FEC, address is 000d.6516.e5aa (bia 000d.6516.e5aa)
Internet address is 10.0.0.1/24
MTU 1500 bytes, BW 100000 Kbit, DLY 100 usec,
reliability 255/255, txload 1/255, rxload 1/255
Encapsulation ARPA, loopback not set
Keepalive set (10 sec)
Full-duplex, 100Mb/s, 100BaseTX/FX
ARP type: ARPA, ARP Timeout 04:00:00
Last input 00:20:00, output 00:00:00, output hang never
Last clearing of "show interface" counters never
Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0
Queueing strategy: fifo
Output queue: 0/40 (size/max)
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
0 packets input, 0 bytes
Received 0 broadcasts, 0 runts, 0 giants, 0 throttles
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored
0 watchdog
0 input packets with dribble condition detected
191 packets output, 20676 bytes, 0 underruns
0 output errors, 0 collisions, 1 interface resets
0 babbles, 0 late collision, 0 deferred
0 lost carrier, 0 no carrier
0 output buffer failures, 0 output buffers swapped out
Serial0/0 is up, line protocol is down
Hardware is PQUICC with Fractional T1 CSU/DSU
MTU 1500 bytes, BW 1536 Kbit, DLY 20000 usec,
reliability 255/255, txload 1/255, rxload 1/255
Encapsulation FRAME-RELAY, loopback not set
Keepalive set (10 sec)
LMI enq sent 157, LMI stat recvd 0, LMI upd recvd 0, DTE LMI down
LMI enq recvd 23, LMI stat sent 0, LMI upd sent 0
LMI DLCI 1023 LMI type is CISCO frame relay DTE
FR SVC disabled, LAPF state down
Broadcast queue 0/64, broadcasts sent/dropped 2/0, interface broadcasts 0
Last input 00:24:51, output 00:00:05, output hang never
Last clearing of "show interface" counters 00:27:20
Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0
Queueing strategy: weighted fair
Output queue: 0/1000/64/0 (size/max total/threshold/drops)
Conversations 0/1/256 (active/max active/max total)
Reserved Conversations 0/0 (allocated/max allocated)
Available Bandwidth 1152 kilobits/sec
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
23 packets input, 302 bytes, 0 no buffer
Received 0 broadcasts, 0 runts, 0 giants, 0 throttles
1725 input errors, 595 CRC, 1099 frame, 0 overrun, 0 ignored, 30 abort
246 packets output, 3974 bytes, 0 underruns
0 output errors, 0 collisions, 48 interface resets
0 output buffer failures, 0 output buffers swapped out
4 carrier transitions
DCD=up DSR=up DTR=up RTS=up CTS=up
Serial0/0.1 is down, line protocol is down
Hardware is PQUICC with Fractional T1 CSU/DSU
MTU 1500 bytes, BW 1536 Kbit, DLY 20000 usec,
reliability 255/255, txload 1/255, rxload 1/255
Encapsulation FRAME-RELAY
Last clearing of "show interface" counters never
Serial0/0.100 is down, line protocol is down
Hardware is PQUICC with Fractional T1 CSU/DSU
Internet address is <ip address>/30
MTU 1500 bytes, BW 1536 Kbit, DLY 20000 usec,
reliability 255/255, txload 1/255, rxload 1/255
Encapsulation FRAME-RELAY
Last clearing of "show interface" counters never
And everything seems to be accounted for to me, but apparently I'm missing something.
My issue is that I'm stuck on interface up, line protocol down, so the T1 doesn't go up.
Any ideas?
Thank you,
