Search Results

Search found 743 results on 30 pages for 'karl brown'.

Page 8/30 | < Previous Page | 4 5 6 7 8 9 10 11 12 13 14 15  | Next Page >

  • How to Enable Ports 25 - 28 on a Cisco Catalyst 3750

    - by Jared Brown
    I am trying to enable ports 25 - 28 on my 28 port Catalyst 3750. These four ports are my fiber ports. I am using the following command to bring up that interface. interface range Gi1/0/25 - 28 That works and it dumps me in the config-if-interface prompt. This is where I get stuck. I just want to enable these four ports and have them be in VLAN1

    Read the article

  • VoIP on Netgear DGN 2000 and Lynksys PAP2

    - by David Brown
    I have a VoIP service running perfectly for outgoing calls but I cannot receive incoming calls. I have a Netgear DGN 2000 modem router on 192.168.0.1 and a Lynksys Phone Adapter PAP2 on 192.168.0.2. I have created 3 new custom services: Service Table Service Name Ports tlenfon(TCP) 5060 tlenfon2(UDP) 15000 tlenfon3(UDP) 35000 I have

    Read the article

  • RJ45 female to male fault

    - by GeoPhoenix
    i have the following - common - problem, on one end of the cable, there are RJ45 males T586 A which are connected to a 8-port switcher, on the other end, there supposed to be RJ45 females _T586 A which in turn will allow another RJ45 male to be connected. the commonly used color scheme was followed on males (having the head down) blue

    Read the article

  • Windows 7 Ultimate x64 / Safari / Downloads disappear

    - by Dayton Brown
    Hi All, Running Safari 4.0.5. When I download a file, it never appears in the download folder. If I pause the download I get the xxxxxx.xxx.download temp file to show up. When I then resume the download, it will finish, but will never rename the file to xxxxx.xxx. I've heard from some other posts that AV seems to have a hand in it,

    Read the article

  • Build of expect v5.43 fails with Tcl v8.5.8

    - by E Brown
    Hi, I'm trying to build "expect" from source v5.43, using Tcl built from source v8.5.8 on Redhat Linux. Tcl built fine, but my attempt to build expect fails. I run configure, then make, which gives me the error: `TCL_REG_BOSONLY' undeclared when compiling exp_inter.c. I did some digging around, and found the TCL_REG_BOSONLY value

    Read the article

  • ssh: which side is running the SOCKS proxy?

    - by Barry Brown
    When I set up a tunnel using dynamic forwarding (ssh -D), which side is running the SOCKS proxy? That is, is the proxy running on the local end (client) or the remote end (server)? Here's the situation: I want to set up several tunnels chained together using -L. Should the -D tunnel be the last one in the chain or the first one?

    Read the article

  • Nginx/puma rhel unix socket permission error?

    - by Kevin Brown
    When I try to start my puma server, I get the error: /.rvm/gems/ruby-2.1.1/gems/puma-2.9.0/lib/puma/binder.rb:275:in `initialize': Permission denied - connect(2) for "/var/run/nvhbase.sock" (Errno::EACCES) My sites-available/nvhbase.conf file: upstream nvhbase { server unix:/var/run/nvhbase.sock; } server { listen 80

    Read the article

  • Redirect to new domain and preserve username

    - by David Brown
    I recently switched to a new domain for a version control server I run. The server is usually accessed with a username included in the url such as https://userinfo@sub.olddomain.com/some/stuff. I want to redirect requests to the old domain to the new domain and preserve everything else in the url (including the username). So

    Read the article

  • Are these three brand new sticks of RAM really dead?

    - by David Brown
    I'm working on a Dell Dimension 4700 desktop for a friend. It came with 512MB of DDR2 RAM (two sticks of 256MB). One morning, it started blue screening on startup with no helpful error messages. It refused to boot into any form of Windows installation, including Safe Mode, original recovery disk, and my custom Windows PE disk.

    Read the article

  • Experience with MooseFS?

    - by brown.2179
    Anyone have any experience using MooseFS? I want an easy distributed storage platform to store static data archive of about 10 TB and serve it to 20-40 nodes. Also I want to be able to add storage as the archive grows without having to rebuild the filesystem. I don't care if it's a bit slow. I just want it to be simple and

    Read the article

  • Iptables - forward email ports?

    - by Emmet Brown
    im trying to open some local ports (LAN) and then re-direct them to another server (WAN) using iptables. Here is my config: #WAN allow-hotplug eth1 auto eth1 iface eth1 inet static #Tarjeta red WAN address 192.168.2.2 gateway 192.168.2.1 netmask 255.255.255.0 #LAN allow-hotplug eth0 auto eth0 iface eth0 inet static

    Read the article

  • Desktop Fun: 21 Cool Ubuntu Wallpapers

    - by Vivek
    Ubuntu 10.04 was released last month, and comes with some breath taking design enhancements, and has some fabulous art work integrated into it. We’ve put together a collection of wallpapers to make it more customized. We thought of pulling out some of the best Ubuntu wallpapers in this post so that you have a good mix

    Read the article

  • Silverlight Cream for April 24, 2010 -- #846

    - by Dave Campbell
    In this Issue: Michael Washington, Timmy Kokke, Pete Brown, Paul Yanez, Emil Stoychev, Jeremy Likness, and Pavan Podila. Shoutouts: If you've got some time to spend, the User Experience Kit is packed with info: User Experience Kit, and just plain fun to navigate ... thanks Scott Barnes for reminding me about it!

    Read the article

  • ArchBeat Link-o-Rama for 11/30/2011

    - by Bob Rhubart
    Coding - the new Latin | @BBCRoryCJ BBC Technology Correspondent Rory Cellan-Jones reports on why "the campaign to boost the teaching of computer skills - particularly coding - in schools is gathering force." BPM Business Value Patterns | SOA Partner Community Blog Juergen Kress shares the presentation he and

    Read the article

  • ArchBeat Link-o-Rama for December 14, 2012

    - by Bob Rhubart
    JMS Step 6 - How to Set Up an AQ JMS (Advanced Queueing JMS) for SOA Purposes | John-Brown Evans John Brown Evans' post continues the series of JMS articles that demonstrate how to use JMS queues in a SOA context. "This example leads you through the creation of an Oracle database Advanced Queue and the

    Read the article

  • Table header is not shown

    - by Vivien
    My error is that the table headers of my two tables are not shown. Right now I am setting the header with new JTable(data, columnNames). Here is an example which shows, my problem: public class Test extends JFrame { private static final long serialVersionUID = -4682396888922360841L; private

    Read the article

< Previous Page | 4 5 6 7 8 9 10 11 12 13 14 15  | Next Page >