Search Results

Search found 3 results on 1 pages for 'riddebaktiyar'.

Page 1/1 | 1 

• IPv4 not enabled in Windows 7

  - by RidDeBakTiYar

  I have a Netbook with Win 7 Starter edition. I am not able to get IPv4 enabled/installed in the Netbook and hence not able to network/connect to Internet. It says "Limited access" when I check connections. It all began when my system crashed and I was not able to get thro beyond the boot screen. The system advice me to try repair with the original OS cd and I did the same. After that the Netbook has booted, but is not able to network. On a detailed study I found that the Network adapter has both IPv4 and IPv6 Protocols, but there are some differences. The IPv4 is not having the "Properties" enabled to configure, while the IPv6 is having "Properties" enabled. I have only a IPv4 Wired and Wireless at home and its not able to get the Netbook connected as it cannot I had tried uninstalling the Adapter to allow windows to automatically detect and install. Using the "netsh" command to uninstall and install, but not having any change in status. There is a option to "Have disk" under add Protocol, but I don't know how to give the standard IPv4 for installation (asking for *.inf). Any help in solving the issue will be very much appreciated

  Read the article

• I/O APIC on Virtualbox

  - by RidDeBakTiYar

  I'm trying to use the PIT to do APIC timer calibration, and I want to use the PIT through I/O APIC instead of PIC. On Bochs I get interrupts from the PIT at the asked frequency from the I/O APIC, while on Virtualbox I can't receive a single interrupt. It must be an I/O APIC configuration problem because as I unmask the first PIC entry, the IRQ fires. However that's not what I want. Can you imagine any possible condition that wouldn't make Virtualbox fire the IRQ? I'm not assuming single I/O APIC configuration (even though Virtualbox has only 1). I'm not assuming identity mappings between ISA IRQs and I/O APIC GSIs (using ACPI MADT table to get I/O APIC base address and Int override). I'm setting the Trigger Mode and Polarity bits correctly (on Virtualbox they are set as '00 - default' which means edge high right?). I'm putting the BSP APIC ID into the Destination field (using Physical destination) and vector 0x20. Being the BSP APIC ID 0 on Virtualbox, it ends up with 0x0000000000000020 written to the IOREDTBL. And, just in case I'm getting the wrong values from the Interrupt Override descriptor, I'm setting this value to all the IOREDTBL entries (I know this is very very bad, and it wont be kept as I understand what's going on). The only thing I didn't check out is Local APIC configuration. Actually I'm not writing any value to the BSP LAPIC. Just reading the APIC ID and using it to boot APs through IPIs. And obviously I'm setting bit 11 in the IA32_APIC_BASE MSR to enable the LAPIC. Any ideas? Thanks in advance.

  Read the article

• Windows 8 update error code 80072EFE? What's the solution?

  - by RidDeBakTiYar

  I keep getting the error code 80072EFE and windows is not installing 11 important updates. Also .NET framework 3.5 is not getting installed it keeps saying that its not able to download. My internet connection is working fine and I am able to browse over the entire internet. I have not changed any of the settings and I am running on Windows 8. The error code I get for .NET is 0x800F0906. Windows live essential are also not getting downloaded. Is there some issue with the Microsoft servers these days?

  Read the article

1