I am fresh for Ubuntu and Linux in general. I have installed Ubuntu 12.04 and stuck trying to setup correct resolution for my LCD display. The native resolution for the LCD is 1920x1080 here is the output from xrandr: $xrandr Screen 0: minimum 320 x 200, current 1280 x 720, maximum 4096 x 4096 LVDS1 connected 1280x720+0+0 (normal left inverted right x axis y axis) 0mm x 0mm 1280x720 60.0*+ 800x600 60.3 56.2 640x480 59.9 VGA1 disconnected (normal left inverted right x axis y axis) Then I create new modeline: $ cvt 1920 1080 60 1920x1080 59.96 Hz (CVT 2.07M9) hsync: 67.16 kHz; pclk: 173.00 MHz Modeline "1920x1080_60.00" 173.00 1920 2048 2248 2576 1080 1083 1088 1120 -hsync +vsync So far so good. then I create new mode using xrandr: $ xrandr --newmode "1920x1080_60.00" 173.00 1920 2048 2248 2576 1080 1083 1088 1120 -hsync +vsync But for some reason that new mode was created for VGA (VGA1) output instead of LCD output (LVDS1): $ xrandr Screen 0: minimum 320 x 200, current 1280 x 720, maximum 4096 x 4096 LVDS1 connected 1280x720+0+0 (normal left inverted right x axis y axis) 0mm x 0mm 1280x720 60.0*+ 800x600 60.3 56.2 640x480 59.9 VGA1 disconnected (normal left inverted right x axis y axis) 1920x1080_60.00 (0xbc) 173.0MHz <---------- ????!!!!!! h: width 1920 start 2048 end 2248 total 2576 skew 0 clock 67.2KHz v: height 1080 start 1083 end 1088 total 1120 clock 60.0Hz So, if I try to add mode to LVDS1, I get an error: $ xrandr --addmode LVDS1 "1920x1080_60.00" X Error of failed request: BadMatch (invalid parameter attributes) Major opcode of failed request: 149 (RANDR) Minor opcode of failed request: 18 (RRAddOutputMode) Serial number of failed request: 25 Current serial number in output stream: 26 Adding that new mode to VGA1 works fine, but I don't use that VGA1 output.