vcsjones - Developer IT

Search Results

Search found 2 results on 1 pages for 'vcsjones'.

Page 1/1 | 1

As a programmer, are you required to do timesheets?

- by vcsjones

Timesheets are something that I've never been fond of, but non-the-less something that is a requirement within my company. They don't bother me so much, but they seem to really grind some other people's gears. I suppose I have a few questions, and feedback would be great. Are you required to do timesheets, assuming you aren't a contractor? (That is understandable to me). What is the granularity of timesheets that you would be comfortable with or that you use? (ex: all entries must be under two hours). Would timesheets ever factor into your reasons for not accepting a job or leaving a current one? How has management within your organization justified timesheets if you aren't billing to a client?

Read the article

VLAN Through Switch Doesn't Work

- by vcsjones

I have the following scenario: I have a Cisco Aironet 1040 access point. I have it configured with two SSIDs, each going to a different VLAN. So: SSID internal : VLAN 90 SSID guest : VLAN 70 On the router side, I have a Cisco RV220W (with the radios now turned off) and have setup VLANs with like VLAN IDs. VLAN 90 : 192.168.90.0/24 VLAN 70 : 192.168.70.0/24 As far as DHCP is concerned, each VLAN has a "DHCP Server" in the router's configuration: So with the access point connected directly to the router, everything works great. I connect to the internal network, and I get a 192.168.90.x address, and the guest network gets a 70.xxx address. Next I introduced a Cisco SG200-50 PoE switch between the router and the access point. The port is configured as a trunk port, so the VLAN tags should go right through the switch back to the router. However, when something is connected to the access point, nothing works. It isn't able to get an IP address, and manually assigning one doesn't seem to let any traffic route. Given that the access point works correctly when connected to the router directly, I believe the switch is misconfigured. What am I missing here? What can I use to better diagnose what the problem might be? It's small business equipment, so CLI access is not available. Below are screenshots of the switch's config. The access point is connected to GE2.