-
as seen on Server Fault
- Search for 'Server Fault'
My colocation provider has setup HSRP for us and has provided us 2 drops (plugged into 1/1/1 and 1/1/2) from their routers as well as a /29 with 2 HSRP IP's and the rest of the /29 usable for the switch.
I know that HSRP should be pretty much plug and play as long as the ports are in the same VLAN…
>>> More
-
as seen on Server Fault
- Search for 'Server Fault'
If I have a router that has several LANs on it, and each of these LAN is attached to a second router, do I need to use different HSRP groups for each LAN?
With this set up, each virtual gateway will be on a Layer 2 segment. And within a router, no interface will have multiple gateways.
So, For…
>>> More
-
as seen on Server Fault
- Search for 'Server Fault'
When using 4 port switching module where each port is configured to switchport access vlan ##, for HRSP should I track the vlan interface or the FastEthernet interface?
interface FastEthernet0/0/0
switchport access vlan 10
interface Vlan10
ip address 12.12.12.1 255.255.255.0
int FastEthernet0/1
…
>>> More
-
as seen on Server Fault
- Search for 'Server Fault'
I want to know if it is possible to do HSRP with 3 or more routers.
>>> More
-
as seen on Server Fault
- Search for 'Server Fault'
Hello all,
Basically what i want to do is to find out what is the mac address of a device plugged in to an interface on the switch (FastEthernet0/1 for example)
reading through the switch documentaion i found out that i can configure snmp trap on it to make it notify of any new mac address the switch…
>>> More
