Broadcom NIC Teaming w/ 802.3ad and Dell Powerconnect 2824

Posted by Carltoncl on Server Fault See other posts from Server Fault or by Carltoncl
Published on 2010-05-28T16:32:02Z Indexed on 2010/05/28 16:34 UTC
Read the original article Hit count: 1254

Filed under:

powerconnect

We have a Poweredge R210 running WS2K8R2. The server has two Broadcom 5716C NICs running Broadcom BASP. I can team the NICs using the 802.3ad protocol on the server end no problem. I have no VLAN.

Now I go to the 2824 switch (default settings all round) running in managed mode and create a LAG with ports g1 and g2. As soon as I add these ports, I lose the ability to send traffic to or from the server.

I am much more of a server guy than a networking guy, what am I doing wrong here?

Server Static IP Address: 10.10.61.15 Network mask: 255.255.255.0 Gateway: 10.10.61.51

The 2824 switch has an IP address of 10.10.61.51 and in turn has its gateway as our firewall server running ISA Server at 10.10.61.50.

Related posts about powerconnect

Windows Network Load Balancing on ESX Cluster with Dell PowerConnect stacks

as seen on Server Fault - Search for 'Server Fault'
We recently switched out our Cisco 6500 core switch for a pair of Dell PowerConnect 6248 stacks. Since then, our Network Load Balanced Sharepoint, which runs on two virtual machines on an ESX cluster has been behaving very poorly. The symptoms are that opening and saving documents stored in sharepoint… >>> More
Broadcom NIC Teaming w/ 802.3ad and Dell Powerconnect 2824

as seen on Server Fault - Search for 'Server Fault'
We have a Poweredge R210 running WS2K8R2. The server has two Broadcom 5716C NICs running Broadcom BASP. I can team the NICs using the 802.3ad protocol on the server end no problem. I have no VLAN. Now I go to the 2824 switch (default settings all round) running in managed mode and create a LAG with… >>> More
VMware vSwitches and Dell PowerConnect BPDU guard

as seen on Server Fault - Search for 'Server Fault'
I am using two Dell PowerConnect 6248 switches to connect a VMware host vSwitch. A discussion of config of Cisco switches for use with VMware advises to set physical ports connected to vSwitch with bpduguard and portfast. However, Dell switches don't have the bpduguard setting for individual ports… >>> More
How to reset password for Dell PowerConnect 2708?

as seen on Server Fault - Search for 'Server Fault'
I do as the user manual says and press "Managed Mode" button to get into unmanaged mode and then press "Managed Mode" button again for managed mode. This should reset the device to factory defaults and username "Admin" with no password. However, the device resets (I think) and I can access the web… >>> More
Why DELL PowerConnect and Juniper are so rare ? Why do enterprises stick with Cisco ?

as seen on Server Fault - Search for 'Server Fault'
Hello ! I have a little question, I'm actually studing IT in France, and when looking on alternative on the very [...] very expensive Cisco equipments, I've found Juniper and DELL PowerConnect pretty attractive on features and price, but I rarely see something else than the classics Cisco/LinkSys… >>> More

Developer IT