Hi,

I'm a linux newbie looking for some help.

I'm currently setting up an XBMC HTPC using a laptop and 10.10 and all works great except for waking from resume using the power button on the remote. The suspend works from remote works fine as does the resume using the power button on the laptop.

I've checked /proc/acpi/wakeup which initially showed the following.

Device  S-state   Status   Sysfs node
C096      S5    *disabled  pci:0000:00:1e.0
C0F1      S3    *disabled  pci:0000:00:1d.0
C0F8      S3    *disabled  pci:0000:00:1d.1
C0F9      S3    *disabled  pci:0000:00:1d.2
C0FA      S3    *disabled  pci:0000:00:1d.3
C0FB      S3    *disabled  pci:0000:00:1d.7
C102      S5    *disabled  pci:0000:00:1c.0
C22B      S5    *disabled  pci:0000:08:00.0
C115      S5    *disabled  pci:0000:00:1c.2
C22C      S5    *disabled  
C118      S5    *disabled  pci:0000:00:1c.3
C22C      S5    *disabled

I've since configured the above so that the S3 devices above are enabled. I've confirmed that they are the correct devices using lspci

00:1d.0 USB Controller: Intel Corporation N10/ICH 7 Family USB UHCI Controller #1 (rev 01)
00:1d.1 USB Controller: Intel Corporation N10/ICH 7 Family USB UHCI Controller #2 (rev 01)
00:1d.2 USB Controller: Intel Corporation N10/ICH 7 Family USB UHCI Controller #3 (rev 01)
00:1d.3 USB Controller: Intel Corporation N10/ICH 7 Family USB UHCI Controller #4 (rev 01)
00:1d.7 USB Controller: Intel Corporation N10/ICH 7 Family USB2 EHCI Controller (rev 01)

None of this has worked unfortunately and I'm now stuck. It simply refuses to wakeup from the remote. The USB receiver shows no activity LED while suspended. Suspend/resume from the remote works fine from Windows 7 so I know the laptop is ok with it.

Any ideas? I need to get this sorted to gain Wife Approval for this system.

Thanks, Bod.