I would like to setup the wake-on-lan, the two PCs are connected through a switch.

Here is the configuration of the eth0, in the BIOS I couldn't find any information regarding the wake-on-lan.

Supported ports: [ TP MII ]
    Supported link modes:   10baseT/Half 10baseT/Full 
                            100baseT/Half 100baseT/Full 
                            1000baseT/Half 1000baseT/Full 
    Supported pause frame use: No
    Supports auto-negotiation: Yes
    Advertised link modes:  10baseT/Half 10baseT/Full 
                            100baseT/Half 100baseT/Full 
                            1000baseT/Half 1000baseT/Full 
    Advertised pause frame use: Symmetric Receive-only
    Advertised auto-negotiation: Yes
    Link partner advertised link modes:  10baseT/Half 10baseT/Full 
                                         100baseT/Half 100baseT/Full 
                                         1000baseT/Full 
    Link partner advertised pause frame use: Symmetric
    Link partner advertised auto-negotiation: Yes
    Speed: 1000Mb/s
    Duplex: Full
    Port: MII
    PHYAD: 0
    Transceiver: internal
    Auto-negotiation: on
    Supports Wake-on: pumbg
    Wake-on: g
    Current message level: 0x00000033 (51)
                   drv probe ifdown ifup
    Link detected: yes

After I shut down the PC, I used different tools to send out the magic package, but nothing happens. Any suggestion?