smartctl not actually running self tests?
Posted
by
canzar
on Server Fault
See other posts from Server Fault
or by canzar
Published on 2012-12-18T00:51:13Z
Indexed on
2012/12/18
5:04 UTC
Read the original article
Hit count: 579
I want to run the smartctl self tests to check the health of the drives in my RAID array (PERC 5/i). The array is on sda and comprises six drives. I can check the status using
sudo smartctl /dev/sda -d megaraid,0 -a
And I see that SMART is available and enabled on all the drives. I have tried to run self tests using
sudo smartctl /dev/sda -d megaraid,0 -t short
and
sudo smartctl /dev/sda -d megaraid,0 -t long
I have also tried it on all of the drives 0-5. No matter what I try, when I run:
sudo smartctl /dev/sda -d megaraid,0 -l selftest
I always get the same result, which seems to always report that I have never run a self test.
/dev/sda [megaraid_disk_00] [SAT]: Device open changed type from 'megaraid' to 'sat'
===START OF READ SMART DATA SECTION ===
SMART Self-test log structure revision number 1
No self-tests have been logged. [To run self-tests, use: smartctl -t]
From what I read, I should have no problem running the short and long self tests on the array while it is mounted. Does anyone else have experience running these tests on a PERC 5/i raid array who could lend some insight into what is causing the problem?
(smartmontools release 5.40 dated 2009-12-09 at 21:00:32 UTC)
© Server Fault or respective owner