How to set a management IP on a Dell powerconnect 5524/5548 switch?
Posted
by
John Little
on Server Fault
See other posts from Server Fault
or by John Little
Published on 2012-06-13T10:06:53Z
Indexed on
2012/06/13
10:41 UTC
Read the original article
Hit count: 1163
dell
|powerconnect
When you first power on a 5524, connected via the serial console, you are offered a setup wizard where you can enter the management IP/Net/Gateway and enter the admin password. HOWEVER, if you dont do this in 60 seconds, the wizard dissapears, and there seems to be no way to run it again - even if you reboot the box.
No commands work in the CLI, it just gives you this prompt:
>
If you type say enable, or login, it gives:
>login
Unknown parameter
May be one from the following list:
debug help
So no commands seem to work.
The CLI reference guide does not seem to have any way to run the wizard, or to set the management port or admin passwords.
So by not responding in 60 secons after boot, the unit is bricked.
Any ideas?
© Server Fault or respective owner