Remove a port from a VLAN (HP ProCurve)

Posted by sixnumber on Server Fault See other posts from Server Fault or by sixnumber
Published on 2012-07-10T09:08:30Z Indexed on 2012/07/10 9:17 UTC
Read the original article Hit count: 189

Filed under:

procurve

I'm not too familiar with switches but I want to remove port 6 from the following 'VLAN 12' I've tried searching for an easy explanation to no avail - How do I do this please?

Port Information Mode     Unknown VLAN Status
---------------- -------- ------------ ----------
5                Untagged Learn        Up
6                Tagged   Learn        Up
8                Untagged Learn        Up
18               Untagged Learn        Down
22               Untagged Learn        Up
26               Tagged   Learn        Up

Related posts about procurve

HP ProCurve GVRP Setup

as seen on Server Fault - Search for 'Server Fault'
I'm trying to setup GVRP on my 4 ProCurve switches. Currently I have a Layer 3 3500yl-24G (J8692A) which is connected to 3 Layer 2 2510G-48 (J9280A). I have three trunk ports setup on the 3500 connected to the 3 switches and currently everything seems to be working, the devices are talking to eachother… >>> More
Load-balancing between a Procurve switch and a server

as seen on Server Fault - Search for 'Server Fault'
Hello I've been searching around the web for this problem i've been having. It's similar in a way to this question: How exactly & specifically does layer 3 LACP destination address hashing work? My setup is as follows: I have a central switch, a Procurve 2510G-24, image version Y.11.16. It's… >>> More
Autonegotiate errors between HP and Cisco hardware?

as seen on Server Fault - Search for 'Server Fault'
This is a bit of a specific extension to this question. I've got two ASA's that feed into a Procurve switch, and then into an IPS. All is well except that the procurve absolutely refuses to autonegotiate with the ASA's...The asa's run 100full, and the procurve autonegotiates to 100half. It does it… >>> More
Is it possible to change the voltage on a single port on an HP ProCurve 2910al POE switch and how?

as seen on Server Fault - Search for 'Server Fault'
I have a couple of HP ProCurve 2910al POE+ switches at my company that we are primarily using to power our VOIP phones that run on 48V DC. However, I have one wireless access point that I need to run off of POE, but it has to be 24V DC. I'm afraid to plug it into the POE ProCurve because I'm not… >>> More
iSCSI SAN Implementation with several ESXi hosts and two Equallogic SANs

as seen on Server Fault - Search for 'Server Fault'
I work for a small state college. We currently have 4 ESXi hosts (all made by Dell), 2 EqualLogic SANs (PS4000 and PS4100) and a bunch of old HP Procurve switches. The current setup is very far from being redundant and fast so we want to improve it. I read several threads but get even more confused… >>> More

Developer IT

Remove a port from a VLAN (HP ProCurve) - Developer IT

Remove a port from a VLAN (HP ProCurve)

procurve

Related posts about procurve

HP ProCurve GVRP Setup

Load-balancing between a Procurve switch and a server

Autonegotiate errors between HP and Cisco hardware?

Is it possible to change the voltage on a single port on an HP ProCurve 2910al POE switch and how?

iSCSI SAN Implementation with several ESXi hosts and two Equallogic SANs

Categories cloud