Cisco redundancy modes
Posted
by
user974896
on Server Fault
See other posts from Server Fault
or by user974896
Published on 2012-11-20T19:19:13Z
Indexed on
2012/11/30
23:07 UTC
Read the original article
Hit count: 259
I am using a Cisco 6500 series with an SSO redundancy configuration. The show redundancy output is as follows:
Hardware Mode = Duplex
Configured Redundancy Mode = sso
Operating Redundancy Mode = rpr
Maintenance Mode = Disabled
Communications = Up
I would assume the device is operating in RPR mode although SSO is configured. What could cause this? Shouldn't the operating mode be SSO?
EDIT (show redundancy states):
my state = 13 -ACTIVE
peer state = 4 -STANDBY COLD
Mode = Duplex
Unit = Primary
Unit ID = 5
Redundancy Mode (Operational) = rpr
Redundancy Mode (Configured) = sso
Redundancy State = rpr
Split Mode = Disabled
Manual Swact = Enabled
Communications = Up
client count = 60
client_notification_TMR = 30000 milliseconds
keep_alive TMR = 9000 milliseconds
keep_alive count = 1
keep_alive threshold = 18
RF debug mask = 0x0
© Server Fault or respective owner